Check out some similar questions!
Chronotherm IV display goes blank when ac activated
[ 1 Answers ]
I was changing out an old mercury switch dial thermometer for my AC to a chromotherm IV T8600D2028. I wired it as instructed with Y to Y, G to G, and R to Rc with a jumper to R. They also give a resistor to wire between Y and W. With this configuration the thermostat activates the AC but then goes...
Honeywell T8001 Thermostat - Blank Display
[ 1 Answers ]
Kids while playing in the backyard were banging against the outside compressor unit and I found later that the display on the thermostat is now blank. So I can not switch on heating or air conditioning. Since my house has two units one for upstairs and one for downstairs, I tested by swapping the...
Thermostat display is blank
[ 6 Answers ]
I have a Honeywell programmable thermostat and the display is blank. We had a bad storm and the power went out. I have checked the breaker and reset it. The blower will come on when I switch it to ON, but nothing else works. Can someone help? View more questions Search
Add your answer here.
|