Ask Experts Questions for FREE Help !
Ask
    PFoglietta's Avatar
    PFoglietta Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 19, 2011, 11:04 AM
    I have a 9 ft umbrella with the word TOWA on the pole. I brought
    I have a 9 ft umbrella with the word TOWA on the pole. I brought it @ Sam's club about 1-1/2 yrs ago. The pivot broke off the top that holds the umbrella and of course to rope broke. Can I buy a replacement pivot anywhere
    Thanks,
    PSF

Check out some similar questions!

Line voltage thermostat wiring: replace single pole with double pole [ 7 Answers ]

Greetings, Current setup: Three small rooms, each with its own 120 volt baseboard electric heat, each with a 25 year old wall mount single pole, line voltage thermostat. All 3 room heaters are on the same breaker. Current single pole thermostat connections have 3 wires: black, red and white....

From double pole to single pole thermostat -2 extra leads [ 3 Answers ]

The double pole thermostat for the baseboard heater has a red and a black wire coming in (from the circuit panel) and a red and a black going to the heater. The new single pole only has a red LINE lead and a black LOAD lead. If I attach red to red and then black to black, I have black (from...

How can I lift or raise a pole that has settled or sunk in an existing pole barn? [ 4 Answers ]

My 25 year old pole barn has a couple of poles that have sunk six to eight inches and I want to jack them up in place. Is there a jack designed for this purpose or a suggested method?

Two Single Pole GFI's = one Double Pole 220v GFI? [ 6 Answers ]

Hello there, Installing a pool motor, 220v hayward northstar two speed. Could not find a double pole 40 amp GFI, electric supply store recommended two single pole 20A GFI's sharing a neutral? Does this make sense. I have a 40amp double pole in the main feeding the sub via the sub panel...

One pole of untied double-pole circuit breaker breaks [ 5 Answers ]

I recently purchased a new dryer (220 v appliance) to replace an older model. The old dryer was connected to the panel via a double-pole breaker except that there was no clip or tie between the poles. I changed the location of the outlet when installing the new dryer, replacing the cable with the...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.