Check out some similar questions!
Line voltage thermostat wiring: replace single pole with double pole
[ 7 Answers ]
Greetings, Current setup: Three small rooms, each with its own 120 volt baseboard electric heat, each with a 25 year old wall mount single pole, line voltage thermostat. All 3 room heaters are on the same breaker. Current single pole thermostat connections have 3 wires: black, red and white....
From double pole to single pole thermostat -2 extra leads
[ 3 Answers ]
The double pole thermostat for the baseboard heater has a red and a black wire coming in (from the circuit panel) and a red and a black going to the heater. The new single pole only has a red LINE lead and a black LOAD lead. If I attach red to red and then black to black, I have black (from...
How can I lift or raise a pole that has settled or sunk in an existing pole barn?
[ 4 Answers ]
My 25 year old pole barn has a couple of poles that have sunk six to eight inches and I want to jack them up in place. Is there a jack designed for this purpose or a suggested method?
Two Single Pole GFI's = one Double Pole 220v GFI?
[ 6 Answers ]
Hello there, Installing a pool motor, 220v hayward northstar two speed. Could not find a double pole 40 amp GFI, electric supply store recommended two single pole 20A GFI's sharing a neutral? Does this make sense. I have a 40amp double pole in the main feeding the sub via the sub panel...
One pole of untied double-pole circuit breaker breaks
[ 5 Answers ]
I recently purchased a new dryer (220 v appliance) to replace an older model. The old dryer was connected to the panel via a double-pole breaker except that there was no clip or tie between the poles. I changed the location of the outlet when installing the new dryer, replacing the cable with the... View more questions Search
Add your answer here.
|