 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
HEIL 7000 gas furnace with 2 questions
Gas ignites stay lit till blower fan turn on then gas flames shut off. Then when calling for more heat same thing happens. Also, noticed some water/moisture in my draft inducer fan housing. Is the moisture normal since it does have hoses connected to it? Many thanks for the help. Rich
|
||||
Check out some similar questions!
My Heil 7000 furnace, installed new in 1993, is leaving a wet spot on the floor just below the lower right panel edge. When I slide my finger along this lower right edge, there is accumulated water, which is dripping ever so slowly, causing the wet spot. What might be the cause of this never before...
On initial start up on my Heil 7000 furnace it is making one heck of a noise until the blower comes on at which time everything is normal. Heater is working perfectly at that point. Do you have any ideas?
We have a Heil 7000 propane furnace. We had it installed in 1993 and haven't used it much over the years. This year when we started using it the motor had froze up and we replaced that part. Draft/flue inducer. I think is what it was called.Anyway after we reinstalled the part now the ignitors...
What would cause furnace flames to go out and relight several times per cycle while the blower continues the whole cycle? Would having basement vents closed cause this? We have lived here 10 years and never opened the basement vents and this problem hasn't been around except recently.
Furnace Info: -Upflow Condensing Gas Furnace is a Heil 7000 (model# NUGK075DG09) -Electric spark or host surface ignitor ( I think it's spark) -Installed Oct. '96 (when we built the house) -90% efficiency -wall thermostat is honeywell programmable. Don't know model but was also purchased in...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
