Ask Experts Questions for FREE Help !
Ask
    mlkimble's Avatar
    mlkimble Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 9, 2011, 05:24 AM
    I have a dgaa070bdtb ser.#wok6895461.
    I replaced the pressure switch and it still does not close and furnace will not come on. What else could it be?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Nov 9, 2011, 06:40 AM
    Check the hose that runs from the inducer assembly to the pressure switch for cracks or holes and make sure its on very tight on both ends
    Also its possible that the inducer motor isn`t running at top speed
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman Furnace Model #DgAA070BDTB Serial # WD95432398 [ 1 Answers ]

When trying to start it will start making a clicking noise then shuts off and then starts flashing 3 green lights consecutively. Why would it do this?

Amperage rating for 6-3 ser [ 1 Answers ]

Can I use 6-3 ser on a stove ? What is ampacity of 6-3 al ?

Ser cable [ 1 Answers ]

Can I run it across the driveway,or put in cable box

SER Cable [ 1 Answers ]

Is SER cable (0,0,0,2) direct bury, or must it be in conduit?

SER run [ 4 Answers ]

Rewiring old house (1927). Just installed a Siemens 200amp all in one(overhead feed) on the side of the house. The wall cavity behind the all in one is only 2X4,the bend in the SER would probably exceed code. So plan to run 2" schedule 80 down and under house(short run) for protection,then run...

View more questions Search