Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Running in wall Coaxial Cable from Existing wall
[ 7 Answers ]
Hi there, Is there someone here who is expert on electrical? I need help on running coaxial cable to my existing walls. I have a 1st floor where I have access to drilling holes into the second floor. I am willing to cut open holes for installing the single gang boxes. Now, here are my...
Bare, tape or dope?
[ 1 Answers ]
I have a copper female adapter soldered on the end of std 1/2 in. copper pipe that will be used to attach a brass faucet. Should I leave the threads bare when screwing the faucet into the adapter or should I use teflon tape or pipe dope? This is being used indoors for the cold water line to the...
How much pipe thread tape to use?
[ 5 Answers ]
Yikes. I was installing the tub spout and the copper stub-out was way too long. I measure and measured again and cut it too short. It doesn't extend far enough Into the spout to seal. Can I use silicone or something? What others options To I have? The spout is the type you described in a...
Bad Tape Job
[ 3 Answers ]
I recently had a chance to by a fixer upper and noticed that the dry wall joints had been badly taped and could be seen through the paint and/or falling off all together. What is the best way to handle this?
Paneling Seam Tape
[ 2 Answers ]
I have put up some new paneling and most of it looks really good, but there are a few seams that show up. My brother told me about using seam tape that matches my paneling, I cannot find this, Lowe's & home depot thought I was on drugs when I asked. Can any one point me to a website or a store that... View more questions Search
|