Ask Experts Questions for FREE Help !
Ask
    rarmstrong's Avatar
    rarmstrong Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 24, 2007, 07:00 PM
    How to connect a leviton 3-way sensor switch
    I have 2 sets of wires with 3 wires at each location. I know which wire is the hot wire coming in (only 1wire at box #1). Other than that I'm not sure where to connect the other wires?
    rarmstrong's Avatar
    rarmstrong Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Jan 24, 2007, 07:15 PM
    Leviton 3 way sensor
    I need to hook up a 3-way sensor at both switches. My switch locations are at separate locations on a 1st & 2nd floor. Therefor I need a sensor at both locations. Will the PR180 leviton 3-way sensor switch work for this application?
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #3

    Jan 25, 2007, 03:55 AM
    I did a search for PR180 in the electrical forum because I remember others having questions and issues with the PR180 used as a 3 way switch.

    Here are a few, they may help, there are several others, you can use the Search Utility on any page of Ask Me Help Desk, use the advanced to get to search the electrical forum only.

    Hope this helps.
    https://www.askmehelpdesk.com/electr...ighlight=pr180

    https://www.askmehelpdesk.com/electr...ighlight=pr180

    https://www.askmehelpdesk.com/electr...ighlight=pr180
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring Leviton 3 way motion sensor switches [ 17 Answers ]

Have done a search and found another post with the same question, but no info on the reslution of the problem. I put in a stairwell to the basement with a landing and 90 deg turn. I have installed a light fixture above the landing to light the stair well and want to control it with motion...

How to wire a Leviton PR180 [ 27 Answers ]

Hello, I purchased the Leviton PR180 to wire into a 3-way switch installation. My setup is exactly like the wiring diagram in the instructions, but I cannot get the #1 switch (original 3 way switch) to turn the lights on after the motion detector has timed out and turned off the lights. I...

MAP sensor;Mass Airflow sensor;Volume Air sensor-All Same? [ 8 Answers ]

97 Nissan Pickup - 160,000 miles - KA24E engine -Check engine Soon Light Code reader says volume air sensor. Is this the same as a mass airflow sensor or the MAP sensor? Where is this sensor located, in the throttle body injection? Just threw a new O2 (Bosch)sensor on it, I lost that bet.. it...

Can you use 2, 3-way Leviton PR180 motion sensors together? [ 17 Answers ]

I am thinking of ventilating 2 separate bathrooms with one attic-mounted Panasonic inline fan. I wanted to install a timer in bathroom A and a timer in bathroom B to control the fan. Unfortunately, there is no such thing as a 3-way timer. The idea of using 2 timers in a parallel circuit crossed...

View more questions Search