Ask Experts Questions for FREE Help !
Ask
    helios14u's Avatar
    helios14u Posts: 4, Reputation: 1
    New Member
    		  
    #1

    Mar 20, 2011, 10:02 AM
    York furance pressure switch
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Mar 20, 2011, 11:17 AM

    Hi helios. What exactly is your question?
    helios14u's Avatar
    helios14u Posts: 4, Reputation: 1
    New Member
    		  
    #3

    Mar 20, 2011, 12:54 PM
    Comment on mygirlsdad77's post
    Hi did clean remove the hose on the pressure switchand lightly blew through tubing then connected one end to the pressure switch and lightly blew through it, disconnected it and connect it to the other port going into the furance and lightly blew into the tubing , reconnected the tubing back up and placed the wiring back onto the switch the mounted to the pressure switch, reconnected power to furance and the furance fired up with no blinking errors and is working fine, my question is that a sign that the pressure switch is going bad and should be replaced or just dirt or obstructions in the line. Please let me know your opinion replace or wait to see if it happens again, the furnace is 14 yrs old.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York diamond 80 pressure switch [ 4 Answers ]

My York diamond 80 furnace does not start. Its message lights 3 times , so according to the table is the pressure switch. I can not find a diagram of the furnace. Where the switch is located?

York residential furnace pressure switch problem code stuck switch [ 1 Answers ]

I have a york furnace P2MD12H06401A after 1 hour it shuts down and gives a 2 flash error for a stuck pressure switch. The switch is new can it be wired wrong? The old one had 2 white wires piggy back and 1 blue wire. The new switch has 3 separate terminals

York Furnances Pressure Switch [ 1 Answers ]

The heat shuts off and have to reset. According to the Manual it seems the pressure switch is locked. Every 15 minutes have to rest it to come on. Can not locate a service to come out to fix it today, Sunday. Have an infant. Need ti try to fix myself. How to replace the pressure switch?

York Heater - Pressure Switch Stuck Open [ 4 Answers ]

I have a York heater that won't heat our second floor. The indicator LED light flashes three times which means the Pressure Switch is Stuck Open. Is there a way I can fix this myself? If so, how? Thanks in advance for any help. John

Pressure Switch for Bryant furance [ 1 Answers ]

Can someone tell me how much a pressure switch for a Bryant furance should cost and is it difficult to install?

View more questions Search