 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Trane Xe80
Our Trane Xe80 gas furnace had 3 flashing lights sucked on pressure switch unit come on. Now have 9 flashing lights indicating ignitor problem. Should both be replaced? I noticed several people paid to have them replaced and unit still did not work. Any suggestions?
Thank You |
||||
Check out some similar questions!
Trane XE80 No code flash means no power/control failure,what should I check first? Jumper wired at stat and control did not blow fuse. Ac works normally but when call to heat is sent fuse blows on control board.
Trane XE80 No code flash means no power/control failure,what should I check first?
My Trane XE80 will ingnite, shut off, ignite, shut off. Cleaned the flame sensor and still have problem that blower motor doesn't come on, but it sounds like it is trying to come on. Could this be the startup capacitor? Also found the diagnostic light - which gives 4 blinks, indicating "Thermal...
My 10 year old Trane XE80 in my woodworking shop lately cannot put out enough heat to satisfy the thermostat, which yesterday was set at 72 degrees on a 37 degree day. The steel building is completely insulated, and this has never happened before at this outside temperature. The furnace seems to...
My thermostat calls for heat, but the blower just comes on and blows air. No heat until I go down and manually restart the furnace. Any suggestions?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
