Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Armstrong ultra sx-80 furnace
[ 1 Answers ]
I have an ultra sx-80 furnace it seems to work fine until it reaches set temp finally it kicks off and acts like it wants to keep trying to come back on every few seconds it will keep doing this until temp falls under set level then kicks back on and works fine until hits set level again then it...
Armstrong Ultra SX 80 furnace won't stay on
[ 16 Answers ]
We have a Armstrong Ultra Sx80 furnace, model GUJ050D10-3A, with a HeatCraft Control Board, cat number 70k98 (40403001). Everything fires up fine… thermostat, inducer motor/fan starts, then ignitor, gas, and the burners light, etc. After the burners are lit for 30 seconds, the blower starts to...
Armstrong ultra sx-80 furnace problems
[ 4 Answers ]
I have an armstrong ultra sx-80 gas furnace my problem is when I turn the unit on it will start up fine when I set it to heat, run for a few minutes then the flame dies. The blower stay on and will not shut off until I unplug the unit. The heat never reaches it's set point. If I wait for about 30...
Armstrong Ultra V Tech 80 Furnace question
[ 0 Answers ]
I own a 6 yr old Armstrong Ultra V Tech 80 furnace. The temp stays current with the thermostat setting, but the furnace keeps kicking on and off every 2 minutes. It will fire up and then burn for a minute, and then kicks off, and then repeats. Any thoughts?
Armstrong air ultra sx 80 furnace
[ 7 Answers ]
I have an Armstrong Air Ultra sx 80 model# GUJ075D10-2B. The furnace has satisfied the call for heat and everything has shut off and waiting for the next call. The problem is on the start-up. When the igniter starts the flame, it is like there is a small build up of gas in the heat exchanger and... View more questions Search
|