Ask Experts Questions for FREE Help !
Ask
    tareef's Avatar
    tareef Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 12, 2010, 09:06 PM
    Kenmore ultrawash dishwasher, fills with water but doesn't spray
    My kenmore 665.1603 or 665.1703 will start working when I select normal wash. It will fill with water and then sit idle. Sometimes you can hear a humm but that's it. I opened the door and I can see water at the bottom but no sign of the sprayers working. The spray arms are not jammed but I feel the water level is low and does not reach the heating element. I tried to raise the float with a spoon to simulate a full tub but that did not help. I also filled the tub with hot water using a watering can but that did not help neither. Any ideas what might be going on?
    Handyman2007's Avatar
    Handyman2007 Posts: 988, Reputation: 73
    Senior Member
     
    #2

    Dec 15, 2010, 09:01 AM

    The timer is bad. Replace it.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore dishwaswher model 665-1372 fills with water but arms won't spin or spray [ 0 Answers ]

New dishwasher hooked up but only fills and drains and sits quiet through wash cycle. Any ideas on the problem?

Kenmore Ultra Wash Dishwasher 665 Pump not working, can't spray water. [ 4 Answers ]

Our dishwasher is only 3 years old. It had been working OK for over 2 years and then it became noisier and noisier. It got to the point where it would fill with water but then the water was not sprayed around inside. We would end up pressing Cancel. We've had 2 different and very experienced...

Kenmore ultrawash dishwasher, fills with water but doesn't spray [ 0 Answers ]

Our kenmore dishwasher fills with water and "pretends" to go through the cycle, but water doesn't actually spray the dishes. It goes through the cycle and ACTS as if it has worked. Any suggestions?

Kenmore Ultrawash Dishwasher leaves 2" of water [ 2 Answers ]

I just installed a used Kenmore Ultrawash Dishwasher and it won't drain completely. I put a new hose on it, so there's no obstruction. It leaves about 2"+ of water in the bottom of it - does sound like the pump is working okay.


View more questions Search