 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Honeywell thermostat RTH111 Delayed Start
We just installed a Honeywell thermostat RTH111 non-programmable thermostat to our forced hot air/oil furnace. When I turn the heat up first thing in the morning, there will be a delay of anywhere from 10 mintues to over an hour before the furnace comes on. It will run to the correct temp and shut off like it should. When heat is required again, you can hear the thermostat click on and the message on the front will say that heat is on but it is not. Then we wait and all of a sudden the heat comes on like it should.
Any suggestions. |
||||
Check out some similar questions!
You put it in drive an there is delay!
I thought the transfer of wiring would be intuitive, but I was clearly mistaken. I have a heat pump with an aux electric furnace. Current connections are (by color) X - blue W2 - white R - red G- green O - orange Y - yellow E - brown Can anyone tell me where these should connect on the...
I am hearing several "thumping" noises in the ventilation when my GMT or GMTH is trying to start. The unit is roughly 6 years old and I have never had a problem with it until now. It thumps maybe 7-10 times then it kicks on and starts working. Thoughts? Thanks.
Honeywell Deluxe Programmable Multistage Thermostat, #T8624D Chronotherm IV Plus I have 2 of above thermostats and have had for about 5 years. It takes no batteries and is directly connected to a 24 volt source. Have one upstairs and one downstairs. Have noticed at times that the LCD on...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
