Check out some similar questions!
Ballpark for compressor fan motor replacement
[ 12 Answers ]
Hello, all. A few weeks ago the compressor fan motor on our 3 ton Trane heat pump apparently died. The unit was only 4 years old, so the part was covered by the Trane warranty. However, the labor to replace the part was not covered. (For what it's worth, the model # of the heat pump is...
Gas furnace takes too long to heat up
[ 1 Answers ]
I'm not sure I have a problem but it seems my gas furnace takes too long to get to the temperature. The room temp. was 55 oF and I set the setpoint temperature to 65 o F. It takes 2 hours to get the room temp. to 57 oF... I stuck my hand to the vent and I can feel a little of warm air but its not...
Carrier Natural Gas Furnace main gas valve will not open every call for heat
[ 1 Answers ]
We have a Carrier Weather Maker 8000 Natural Gas Furnace not functioning properly. We have replaced pressure switch, hot surface ignitor, flame sensor and control board. It will cycle 3 to 4 times and then not come back on. Is it possibly a bad coil on gas valve?:rolleyes:
Gas Furnace Maintenance: How Often & How Long Should it Take
[ 2 Answers ]
Hello, I am trying to figure out the "real deal" on how often I should be having my gas furnace maintained (as well as rooftop AC unit). I had a new gas furnace and rooftop AC installed a couple of years ago. Works great. I had a "maintenance agreement" with the company who installed it. ... View more questions Search
Add your answer here.
|