Gas furnace will come on but no sound of it igniting or blower firing up

eldawge Posts: 1, Reputation: 1

New Member

Nov 6, 2010, 02:15 AM

Gas furnace will come on but no sound of it igniting or blower firing up

Joshdta Posts: 2,549, Reputation: 45

Ultra Member

Nov 6, 2010, 06:28 AM

Look in the bootom door for a flashing fault code.

Add your answer here.

Check out some similar questions!

Gas furnace (steam) not igniting, pilot is lit. [ 0 Answers ]

I have replaced the switch on the side of the unit and tried to jump the thermostat and it didn't spark. Not sure what the problem is, the heat had come on automatically a week before. Any ideas on what happened and what the solution could be?

Craftman gas blower not firing,where ignition-module [ 0 Answers ]

Craftman gas /leafblower not firing,new plug,clean carbon depoist from piston, cylinder bore still not cranking, any ideas?

Goodman gas furnace not igniting [ 1 Answers ]

Suddenly the furnace is not igniting, we can light it manually and the furnace kicks on, but once it reached the desired temp, it will not ignite itself when the temp goes back down. Where do we start troubleshooting?

Bryant furnace blower motor running, but not firing [ 3 Answers ]

What should I check to see why my gas furnace is not firing. I replaced the blower motor, which it is working also reset and then wired around the limit switch on the blower housing. Was working and firing furnace producing heat. Within one hour. Then the blower motor comes on, but the...

Concord furnace not igniting - no click sound [ 1 Answers ]

I have a Concord 80% furnace apx. 4.5 years old. It has not been used for 6-7 months as the tenants were not paying the gas bill. Now that they are out, I went to start it up... and nothing. I get the igniter to light (M shaped Norton) and the system cycles, blower runs, but no "click sound"...