Ask Experts Questions for FREE Help !
Ask
    masoned's Avatar
    masoned Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 18, 2010, 09:20 AM
    Stuck Tub bucket and rod assembly
    Cannot pull out bucket and rod assembly in tub. Stuck. What do I do?
    afaroo's Avatar
    afaroo Posts: 4,006, Reputation: 251
    Ultra Member
    		  
    #2

    Oct 18, 2010, 09:58 AM

    Remove the trip plate see the Image below and Pour some white vinegar in there. Repeat several times over a day. You could also use CLR or LimeAway, good luck.

    John
    Attached Images
     
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #3

    Oct 18, 2010, 12:54 PM

    In addition to Johns solution I've had luck using WD40. When you get the bucket out clean it up with some steel wool. Good luck, Tom
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replace Tub Drain Assembly? [ 2 Answers ]

I tracked down a tub leak coming from where the brass tub drain/overflow assembly connects with the ABS drain pipe (installed 30+ years ago). This will make the third similar repair I have done within the last 18 months. Is this typical for a 30+ year old house? Since I had to cut into the...

Tub drain plunger separated from trip lever assembly [ 1 Answers ]

I had a plumber fix a tub drain plunger. Apparently, instead of fixing or adjusting the old type (lever to visible stopper), he must have replaced it with a newer type (lever to internal stopper). Problem is that the lever is now disconnected from the internal stopper. The eye hook at the bottom of...

Tap assembly stuck [ 2 Answers ]

I am trying to replace one of my taps from my kichen mixer tap assembly. Unfortunately I cannot move the nut that fastens the tap to themain body of the assembly.

Replace tub drain assembly w/o dumbbell wrench [ 4 Answers ]

Please help. I need to replace my pop-up drain assembly in a bathtub in a house we just bought. I tried to do it using a dumbbell wrench but the cross section that the wrench grabs onto was corroded and broke off. Therefore, there's nothing left to grab. I read somewhere that you can do...

Leak in New Tub Drain Assembly [ 3 Answers ]

I just installed a new bath drain kit. Upon testing there is a small leak at the connection of the brass waste shoe and the brass tee connector. In this kit a slipnut tightens a rubber washer to seal that connection. Is there anything else I can use to seal that connection? Thanks. Steve

View more questions Search