Where the expansion bulb suppose to be located on the vapor line

Check out some similar questions!

Upon installation of bulb, base of bulb burns and bulb never lights [ 1 Answers ]

Installed two new 3 bulb post lights on concrete entry piers, one bulb pops and burns the base immediately upon installation... I have checked the wiring and everything is wired correctly, I assume ths is a bad bulb socket and the fixture is defective, has anyone had this problem before?

Suppose a typical 60-watt incandescent light bulb costs $0.51 and lasts 900 hours... [ 8 Answers ]

Does it make financial sense... Suppose a typical 60-watt incandescent light bulb costs $0.55 and lasts 800 hours. A 15-watt CFL, which provides the same light, costs $3.45 and lasts for 9,900 hours. A kilowatt-hour of electricity costs $0.117. A kilowatt-hour is 1,000 watts for 1 hour. You require...

Located stolen computer on line - next steps? [ 3 Answers ]

Hi, I had a computer stolen, and a few weeks later, I was able to locate it online, and download information off it. I have detailed information of the person, and I have forwarded the information to Police. Unfortunately, the investigative offices shift ended Friday afternoon, just hours...

Installing Expansion Tank on flex supply line [ 5 Answers ]

Hello, I have a 55gal water heater and is supplied, and outputs via copper flex lines. There is standard copper coming out of the wall, a shutoff, then flex to the water heater supply, then flex out back up to the wall, where there's another threaded connection. So, my question is, can I just...

High sodium vapor bulb life [ 1 Answers ]

I am using high sodium vapor lights in an agricultural setting and require that a certain amount of lumens be available. I am wondering if the amount of light emitted declines over time and if the bulbs should be replaced before they burn out to ensure that the amount of lumens emitted remains...

View more questions Search

Check out some similar questions!

Add your answer here.