 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I'm installing a utility sink in the garage. I'm teeing into the laundry drain on the other side of the wall. I undersatand I should install an AAV just beyond the p-trap as so I won't suck the laundry p-trap dry that is just upstream from that point. However.. here's my delemma. The sink is 36"...
I want to install a utility sink in a garage where there is an existing unused washer/dryer hook-up. Can I connect the sink directly to the unused washer drain? This seems like it should be pretty simple, am I missing something? Thank you.
I have a utility sink in my walk-out basement - that sink's 1.5 inch drain connection is approx. 18" above the floor, into a two inch horizontal run. This 2 inch horizontal PVC runs about 3 feet, then connects to a main 3" DWV. I would like to add a bar sink, set into a standard height (36")...
I will be removing a utility sink and cabinet and will not be replacing it. My question revolves around the drain coming out from the wall.The water lines have shut off valves which will remain in place in case the utility sink were to be needed at a later time so they are not the issue. Can I...
I am planning on adding a utility sink to my laundry room, I was planning on tapping into the water lines and drain to the washer. I have not opened up the wall yet so I don't know the exact configuration of the drain, but my question is if I run the sink drain of off the drain from the washer...
View more questions Search
|
