Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Low cold water pressure in 2 showers... Not back to back config however
[ 8 Answers ]
My home is 16 years old, I've had it for 5 years. I am on a pump - with 70LBS high cutoff and 55lbs Low turn on. All copper - I have 2 Delta 1600 shower faucets - one tub spicket with shower diverter - one shower only. The tub/shower combo has allways had only a trickle of cold water and...
Ball missing in sewer drain to prevent back flow
[ 1 Answers ]
Is there any way to replace the missing ball in my basement floor drain without completely removing the existing pipe and concrete floor? The drain has backed up a few times but nothing major; a partial clog has been removed. I would like to replace the ball before anything serious happens. ...
Washer back up - not a clog!
[ 4 Answers ]
Our basement floor drain began backing up after washing several loads of laundry in a row. Our plumber explained that there was a clog in the line between this drain and the street but since there wasn’t a cleanout, they would need to dig up the floor and place one in the line. After the cleanout...
Washer back up into sink
[ 2 Answers ]
:confused: When the washing machine drains it backs up into the kitchen sink which is about ten feet away then drains out. This sink drains very slowly, if I plung it once or twice it drains fast.
Washer hose flow valve
[ 3 Answers ]
I just bought new washing machine connectors at a national home improvement store. They are billed as flood preventative because they have a diaphram valve at the connector which shuts down water flow when flow exceeds 2.5 gpm. However, I can only turn on the water valves less than a quarter of a... View more questions Search
|