 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I'm trying to install a VisionPRO TH8000 honeywell thermostat... help!
I am replacing an old 1070's WeatherTron stat Mod# 3AAT80B1A1 (or 2A1) 30 volt AC 1.5 amp for a GE Heat Pump with air conditioning. Wires: X2-Black, Y-Red w/Black, G-Green, O-Orange, T-White w/Black, R-Red, B-Black, W-White. I'm replacing it with a Honneywell VisionPRO TH8000 stat. HELP!! Thanks!
-Bob |
||||
Check out some similar questions!
How do I setup the honeywell with only 2 wires? 1 wire was hooked to W and 2nd wire was hooked to R on old one.
Thanks in advance for taking my question. Let me level set. I am a homeowner not a contractor and thus my experience is fairly limited. I am attempting to replace two digital MapleChase 9610 thermostats that are connected to a two zone (mini zone Temp-A-Trol) panel. I called The zoning...
How do I go about entering the temperature for my backup heat source (in my case, gas) to kick in? I believe it was set at 35 degrees, but I want to confirm. Thank you
This thermostat was installed only 8 months ago and has worked fine until last night. It began a humming sound and the thermostate vibrates. What is causing this? The heater is working fine and all displays are normal. It is just this loud sound that is emitting from the thermostate itself and...
When this thermostat call for aux. heat, it reads aux. heat on the pad but no heat. The aux. heat works in manual mode. I think a setup code is wrong since it has never done right. Could someone help.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
