Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Carrier furnace cuts out
[ 3 Answers ]
Has any one found a solution for the Carrier weathermaker furnaces when they fail to cut in when the thermo calls for heat. I have to turn off the power at panel box or kill switch for 5/ 10 seconds then flip back on then the furnace will cut in, apparently some kind of safety sensor, but it does...
Lennox oil furnace
[ 3 Answers ]
What is the proper procedure for cleaning a oil furnace, such as cleanouts to heat exchangers and where could I find a exploded view of a lennox oil funace
Furnace flame cuts out
[ 10 Answers ]
Having problems keeping flame burning in furnace.Oil furace hadn't been used in 2 years and had oil delivered recently.We figured the tank would be close to empty but were told after it was filled that it was already over 1/3 full. Furnace would light up with yellow flame but then turn blue and...
Oil burner Blower cycling on and off
[ 2 Answers ]
Just finished with a new second floor addition. Upgraded to two zone heating from single zone. When heat comes on after expected delay for temp to rise the blower comes on for fifteen seconds then kicks off and comes on again in about two or three minutes, and kicks off again in fifteen seconds, on...
Oil Burner Furnace
[ 1 Answers ]
The problem goes like this. Thermostat calls for heat, burner starts and runs for a minute or so and shuts off. After burner shuts off, the blower starts and the burner starts again until the thermostat reaches temp and the burner shuts off blower contiues to run until the low temp limit is... View more questions Search
|