Ask Experts Questions for FREE Help !
Ask
    wallace1920's Avatar
    wallace1920 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Aug 5, 2010, 12:38 PM
    a.c motors
    Why when the brush Yoke on an a.c. motor is moved to the reverse position it won't run
    wallace1920's Avatar
    wallace1920 Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Aug 5, 2010, 12:41 PM

    Why when the brush yoke on an a.c. motor is moved to the reverse position it won't run
    kryostar's Avatar
    kryostar Posts: 108, Reputation: 11
    Junior Member
    		  
    #3

    Aug 8, 2010, 01:02 PM

    Do you mean removing the brush turning it 180degrees and putting it back in? Electric motors are finicky about about their brushes if worn out you should just get new brushes and clean rotor where brush contact is made with a pencil eraser.hope that answered you question please rate my answer thanks:)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

ECM motors [ 5 Answers ]

Would appreciate your comments on how to test ECM motors and ECM board . I know that these motors are energy saving and really prices motors . Tks all

Comparison between single phase motors & three phase motors [ 3 Answers ]

Why single phase motors draws more current than three phase motors

3 phase motors and single phase motors [ 4 Answers ]

Mike holt stated on one of his classes that in order for any eletrical equipment to work, that on one end had to be voltage and on the other side it had to have no voltage. So when the voltage goes to a three phase motor where does it go? Does it go to ground? I understand that the 3 phases are 120...

Electric motors [ 1 Answers ]

Motor has 6 poles is 3ph would like to convert to 1 ph

View more questions Search