Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Donut shaped conference table center access
[ 1 Answers ]
I am building a 16' diameter conference table with a 10' diameter center. The table top sits on a base, but the customer wants access to the center area for vacuuming and cleaning. I'm trying to figure out how to accomplish this! I have a pretty good sized budjet for the project, but I want to be...
Donut Into Hub Leak-Back Concern - Rebuild
[ 2 Answers ]
OK, it's time to rebuild. I've purchased the 3" donut, but it does not appear that it will create a water-tight seal between itself and the hub, even after I slide the 1.5" PVC pipe into the donut. My concern is without a water tight seal, this upstairs bathroom sink drain will leak past the donut....
Head gasket
[ 4 Answers ]
I have a 2000 suburban and I notice on start up the smell of antifreeze, does anyone know what that could possibly indicate?
Sealing with cast iron hub donut?
[ 10 Answers ]
Following the sage advice found on this site in other postings, I managed to remove the misshapen, rusted waste pipe that went from my downstairs toilet to the horizontal main line (cast iron). So now I have a cleaned out bell and test fitted a neoprene donut from Lowe's (4" to 3") and plan on...
Adhesive with gasket or not
[ 2 Answers ]
I am installing a PVC shower stall drain in a fiberglass shower unit. The drain unit has a rubber gasket and a friction gasket. Should I install the drain with or without a (latex adhesive) caulk applied to the gaskets? A picture of the drain unit is attached. (I hope) View more questions Search
|