Ask Experts Questions for FREE Help !
Ask
    rachel34's Avatar
    rachel34 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 13, 2010, 05:03 PM
    Whirlpool Duet
    I have Whirlpool Duet and it shuts off after one minute, and reads E1. What could I do to fix it?
    applianceman's Avatar
    applianceman Posts: 30, Reputation: 2
    Junior Member
     
    #2

    Jul 13, 2010, 06:56 PM
    E1 code
    According to the service manual an E1 code means an open thermistor or wire harness...
    THERMISTOR
    Refer to page 4-7 for the procedure for servic-
    Ing the thermistor.
    The thermistor monitors the exhaust temper-
    Ature and cycles the high-limit thermostat on
    And off to maintain the desired temperature.
    1. Turn the dryer off but keep the electrical
    Supply connected.
    2. Make sure that the dryer is empty and that
    The lint screen is clean.
    3. Close the dryer door.
    4. Select Heavy Duty, Timed Dry, More Time
    Or Less Time, End of Cycle Signal (Louder)
    And Start.
    5. If error codes E1 or E2 flash on the dis-
    Play after 1 minute and the dryer turns off,
    The thermistor, or the wire harness, is ei-
    There shorted or open. Check the wire con-
    Nections at the thermistor or the machine
    Control electronics board. If wiring checks
    Okay, replace the thermistor.
    6. If the dryer seems to operate normally, re-
    Move the exhaust vent and start the dryer.
    7. Select the desired temperature cycle to be
    Tested, and select 20 minutes of Timed Dry
    Heat using the More Time or Less Time
    Pushbuttons.
    8. Hold a glass bulb thermometer capable of
    Reading from 32°C to 82°C (90° to 180°F)
    In the center of the exhaust outlet. Mea-
    Sure the exhaust temperatures with the
    Heater on and off. The correct exhaust tem-
    Peratures for the various settings are
    Shown in the following chart.
    9. If the exhaust temperature is not within the
    Specified limits, check the resistance of the
    Thermistor, as shown in the following chart.
    If the resistance is okay, replace the ma-
    Chine control electronics board.
    TEMP RESISTANCE TEMP RESISTANCE
    °C (°F) (K Ω ) °C (°F) (K Ω )
    10° (50°) 19.9 43° (110°) 4.7
    16° (60°) 15.3 49° (120°) 3.7
    21° (70°) 11.9 54° (130°) 3.1
    27° (80°) 9.2 60° (140°) 2.5
    32° (90°) 7.4 66° (150°) 2.1
    38° (100°) 5.7 71° (160°) 1.7
    THERMISTOR RESISTANCE
    TEMPERATURE HEAT TURNS HEAT TURNS
    SETTING OFF ON
    68° C ±6°
    (155° F ±10°)
    MEDIUM 66° C ±6° 6 - 8° C
    HIGH (150° F ±10°) (10 - 15° F)
    60° C ±6° below the heat
    (140° F ±10°) turn off
    52° C ±6° temperature
    (125° F ±10°)
    EXTRA 41° C ±3°
    LOW (105° F ±5°)
    HIGH
    MEDIUM
    LOW

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Whirlpool duet GHW9400 [ 0 Answers ]

It is displaying an error Code FH when starting wash and stops, then I resart the washer and it stops a few minutes into the fill. I have tried all the trouble shooting tips but they did not solve anything. This seems to be getting worse

Whirlpool Duet Dryer [ 2 Answers ]

My Whirlpool Duet Dryer is less than 2 years old. The control panel lights do not come on even though the interior light comes on. The repair man has been here four times to the tune of $ 400.00. He said it was the control panel and it needed to be replaced. That took a week to get parts, but it...

Whirlpool duet dryer [ 4 Answers ]

Hi, I have a Whirlpool Duet dryer model #GEW9200LW0 IT WONT START! The controls light up but all it does is beep when I press and hold the start button. I have tried. Made sure the door was closed.. lol;) Unplugging and plugging back in Locking and unlocking the controls Checked the...

Whirlpool duet dryer '07 model [ 1 Answers ]

The lite on the left bottom of the dryer is lit that says "control lock" which prevents the dryer from turning on, I cannot get it to shut off. Any knowledge on this? I do not have a manual. Thanks

Whirlpool Duet [ 1 Answers ]

What does the error message "F 70" mean on my brand new whirlpool duet dryer?


View more questions Search