Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Do you have to change the copper pipes that feed the lp if converting to natural gas?
[ 2 Answers ]
We currently have copper pipes that feed the propane to our house and are converting to natural gas. Do we have to change the piping that we currently have? Thanks a bunch. RJ Melton :)
Slight natural gas leak at iron union joint
[ 1 Answers ]
There is a small natural gas leak that persists at the black iron union joint on the short line between a local gas shut off valve and the furnace. The leak is so small and the union joint so hard to bubble test that soap bubbles just don't show the leak clearly, but the odor is definitely there. ...
How to conect copper threaded tee to copper piping
[ 14 Answers ]
I tried to install a copper threaded tee which connects 2 ends of copper piping and a line to dishwasher (plastic hose). Still a dripping leak at the joints.
Bonding Natural Gas Piping
[ 5 Answers ]
I had a natural gas system installed in my home and bonding the pipe entering the home has been a problem with the inspector (VA - Fairfax County). Anyway my HVAC contractor grounded the black pipe to the cold water copper with #6 AWG; however, the inspector is telling us the pipe needs to be...
Copper piping pressure
[ 1 Answers ]
I am not sure if this is the correct forum to ask this question therefore if anyone can assist or direct me to the correct forum, I would appreciate it. My question is about running piping for an air compressor. I have a 135 PSI compressor and need to run pipe about 70 feet from the compressor. ... View more questions Search
|