|
|
|
|
New Member
|
|
Dec 8, 2006, 10:48 PM
|
|
Burners won't... follow up info
Burners light for couple seconds, then go out
Weather King --- ICECO --- 80 PJ --- forced air --- Honeywell valve (on/off switch)
Burners try to light on 1'st attempt, lights for couple seconds then out on2'nd attempt.
Brand new furnace. Looked in installation manual -- says stuff about igniton sequence,
Tries 4 times, soft lockout, etc.. also something about flame roll out safety switches--
Maybe need to reset? Am kind of afraid to mess with this to much-- don't want to blow up.
|
|
|
New Member
|
|
Dec 8, 2006, 10:54 PM
|
|
Originally Posted by dvqjimbo1
Weather King --- ICECO --- 80 PJ --- forced air --- Honeywell valve (on/off switch)
burners try to light on 1'st attempt, lights for couple seconds then out on2'nd attempt.
brand new furnace. looked in installation manual -- says stuff about igniton sequence,
tries 4 times, soft lockout, etc..
need this info?
YES
|
|
|
Uber Member
|
|
Dec 8, 2006, 11:13 PM
|
|
Go over what the manual says about the flame roll out switch very carefully. If the control doesn't get the signal from the roll out switch that it has flame very soon after turning the gas on, it will turn it back off and try again a few times. If after about 3 times, and no flame signal, it quits for a while, lockout. My guess is that with a new furnace, the rollout switch is missing, misplaced, or not connected properly. Figure out the problem, and the furnace should run.
|
|
|
Ultra Member
|
|
Dec 9, 2006, 09:14 AM
|
|
If this is a new install and burners light but don't stay lit I would make sure the furnace is properly grounded and that the high voltage is correct polarity, 120 volts to black and neutral is white.
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
Carrier Furnace - Burners turn on and off
[ 2 Answers ]
On my Carrier furnace (model 58G5100-2) the igniter starts the pilot, and most times the pilot starts the burners after a minute or two and then the blower motor starts.
Other times, pilot lights the burners which burn for a minute or two, stop and then start again... and after a few minutes...
Follow Up on the Ex
[ 7 Answers ]
We started talking regularly again about 2 months ago. I was involved in a very bad accident, and was hospitalized and in a coma. My sister text messaged everybody in my phone to inform them of my status and the Ex's number was still in there. When I came to she was one of the first people to call...
Burners won't light, or, stay lit
[ 3 Answers ]
1'st time trying to turn heat on with new furnace-- hot surface ignition system -- burners don't light , or, stay lit -- can't tell which. Any special sequence needed to light?
Any help appreciated
Carrier split - heat burners cycle on and off
[ 7 Answers ]
Carrier split unit in heat mode appears to basically operate OK. Once the pilot is lit and the burners come on, the pilot remains lit but the burners will intermittently cycle on and off. This appears to sometimes delay the blower from turning on. Once the blower turns on, it heats to the set temp...
View more questions
Search
|