Ask Experts Questions for FREE Help !
Ask
    donovan harris II's Avatar
    donovan harris II Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 2, 2006, 06:35 PM
    Kenmore "elite" dryer
    Do you know which connections are which for the electrical cord wiring? I've got to change the three prong factory cord to a four prong cord which, for one thing has four wires where the other only has three, and the factory cord has three grey wires that are not identified as to which wires are which (pos. negative. grnd.)?? Someone please help so I can quit hand-washing and "line"-drying my clothes all over the place :)
    andrewcocke's Avatar
    andrewcocke Posts: 439, Reputation: 22
    Full Member
    		  
    #2

    Dec 3, 2006, 09:57 AM
    The two connections on the sides are for your voltage, the one in the middle is for the neutural. The dryer's fourth wire is for the ground, and it should be attached to the frame of the dyer.

    This website shows a great illustration of this:

    http://fixitnow.com/appliantology/dryercords.htm
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Fan Blower not working in "ON" or "AUTO" in heat or AC [ 13 Answers ]

Got home from the Brewer game this afternoon and noticed the house was warm(78). Outside was 91. I checked the T-stat and it was set correct. Noticed the air vents weren't blowing anything. Went outside and the condenser and fan was running fine. Then I went downstairs to the furnace unit to see...

Kenmore Elite Calypso "ob" error message [ 1 Answers ]

Hi! I can't find my manual on my washer. It's a Kenmore Elite Calypso. It goes through most of the cycle and towards the end I get "ob" error message. I'm thinking it means off balance, but it has been balanced. Any suggestions? Thanks, Bridget

My Kenmore gas drter has low heat "HELP" [ 1 Answers ]

Hello to all I have a Kenmore elite large capacity gas dryer model # 110.70942990, SER: MK2413999 The problem I am having is I only get low heat when its on the cotton setting, in the last week it has been taking about 2 hours to dry a normal load that use to takes about 45 minutes, in the past...

"F" error on Kenmore he3 washer [ 0 Answers ]

I got an "F" error on my washing machine. I can't find the manual to find out what it means. Can anyone help?

Whirlpool Dryer - itermittent "fluff dry" cycle stops [ 4 Answers ]

Our Whirlpool dryer has a cycle for intermittent dry or fluff cycle... it seems that it runs fine, then when it shuts down at the intermittent of fluff cycle it will not turn back on again, any thoughts? Kirk

View more questions Search