Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Goodman not igniting burners
[ 32 Answers ]
Have a Goodman 80% efficiency furnace inside our home, installed in a new home that is 2 years old and still under warranty. The igniter will not stay lit long enough to ignite the gas. The process starts blower comes on, click, igniter lights, igniter goes out, you hear the gas released but...
My Goodman furnace cuts on for 1 sec
[ 7 Answers ]
The status light blinks continuously which the panel states is either incorrect twinning or incorrect primary polarity. It suggests that I check "reverse transformer," "secondary leads," and "reverse primary wires." My diagram does not label these parts. Is there a part that I might replace or...
Goodman furnace burners
[ 1 Answers ]
How do I ignite the burners on a goodman furnace?
Goodman Heater runs 5 sec, 3 cycles and stops
[ 5 Answers ]
I have a goodman forced air furnace and it lights up for 5 secs... shuts down... 3 cycles of this and stops. I cleaned the heat rod with NO success and was just wondering if I should buy a new heat rod (where if so) or may it be another issue? THanks David
Goodman furnace igniter stays on 20 sec with pilot light
[ 1 Answers ]
Have a Goodman forced air unit in my garage, was used only now and then, a while ago it started this... turn furnace on and igniter comes on and lights pilot then stops for a second then comes back on for about 20-30 seconds... all this time pilot is light and strong... then igniter stops and... View more questions Search
|