Ask Experts Questions for FREE Help !
Ask
    ultrarick's Avatar
    ultrarick Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 10, 2010, 01:58 PM
    Air ease ultra sx 90 draft inducer fills with water
    I have air ease ultra sx 90 furnace the air inducer fills with water and will not reach starting speed. I must remove a drain plug and let water run out before it will start.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 10, 2010, 02:43 PM
    See if the condensate drain on the furnace is restricted or plugged up. Also check for restrictions in the exhaust line going outside especially for ice blocking discharge outside.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Draft inducer troubleshooting [ 3 Answers ]

I have a 5 yr. old dunkirk xeb3 boiler. This year on starting I noticed a smell of burnt gas coming out from around the draft inducer housing. I checked housing and gasket, both seemed fine. Fan only runs for approx. 5 seconds before ignition, and shuts off right after flame stops. Could this be...

Draft inducer does not start [ 1 Answers ]

...

The Power Venter (aka Heat Inducer and Draft Inducer) will not start on Goodman. [ 8 Answers ]

FURNACE: Made by: Goodman Model #: GMPN080-4 THE POWER VENTER (this is what the Goodman manual calls it but other websites refer to this as the Heat or Draft Inducer): Made by: FASCO Industries 70219565 Type: U218 Volts: 115 RPM3400 Customer Part #: B2833001S

Forced hot air issue (Draft inducer fan) [ 1 Answers ]

My draft inducer fan is running for about 3 minutes before the furnace ignites. Once it ignites,the furnace is operating correctly. This seems to be longer than normal. Any ideas on what's wrong, or what I need to check/test? Thanks!

No voltage to my draft inducer [ 3 Answers ]

I have a Janitrol Furnace that will not start up. I pulled of the tube from the draft inducer to the pressure switch. I sucked on the tube and the furnace fired up. So I checked the voltage going to the draft inducer, it read only 6v ac. Where do I go from here?

View more questions Search