Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Generac 7550 EXL Generator - Motor Runs - no power
[ 3 Answers ]
The unit quit putting power out motor runs I am getting 4-5 volts out of the receptacles I took the cover off the end unplugged the connector from the windings to the control panel and got 1.5 - 2.5 volts out of each lead (4 total) I checked for continuity between the leads and have it between...
Snowblower won't start, made bad noise using electric, pull cord now hard to pull.
[ 7 Answers ]
I tried to start my snowblower today and it wouldn't start. I decided to try the electric start, plugged it in, hit the start button and all it made was a spinny grinding noise. Unplugged it, and tried to start it manually with pull cord again. The cord would not pull without lots of effort and...
Pull cord won't pull on Murray 2.0 mower
[ 7 Answers ]
I have a Murray/Briggs 6.0 engine mower and the pull cord is sticking. It will stop after pulling about 4 inches. Then if I jiggle the pull cord it will extend another 4 inches. I can see a plastic piece that seems to be stopping it at every four inches. What is causing this and what is the repair...
Generac generator starting problems
[ 1 Answers ]
My generator turns over constantly but won't start. What could be the problem?
Lawnmower pull cord won't pull
[ 1 Answers ]
When I tried to start my mower by pulling the cord, it wouldn't budge. Nothing I did made it move an inch. What happened and how can I fix it? :( View more questions Search
|