Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Wiring Hot Tub and using a 50 Amp Double Pole GFCI Circiut Breaker
[ 10 Answers ]
:confused: I keep getting the GFCI breaker tripping after wiring my hot tub. I wired 2 hot Red and Black to the proper terminals and the White to the neutral and the Bare Copper to the ground Post at the tub. I am using 6-3 w/G per instructions. Could the GFCI breaker be bad? When I wire...
No Hot Water to shower head, but Hot water to the Tub?
[ 2 Answers ]
My husband and I just purchased a new house. We have found that the shower pressure in the bathroom is wonderful however once you have set the right temp from the tub spout and switch over to the shower no hot water makes it to the shower head. We can only turn off the cold water completely in...
Hot Tub Electrical Wiring
[ 1 Answers ]
I am getting ready to install a Dimension One spa that the manufacture calls for using #6-3 awg wire and 240 Volt - 50 Amp with a GFCI breaker and disconnect. I had the house pre wired for a hot tub and 240 Volt service. They installed a 50 Amp breaker in the main box and ran about 40...
Hot tub g.f.I
[ 1 Answers ]
I recently hooked up a hot tub that required a 240v with no neutral. (50A) I took a two pole 60 from the main service and ran 6/3 teck cable to a 2cct outdoor enclosure outside to within 5' of the tub. Into the enclosure I hooked up the red to the main the black to the other main and the blue to...
Hot tub 240
[ 1 Answers ]
I have a 240 hot tub but no 110 close. I was thinking about running a line to the hot tub controls and use 1 leg of 240 circuit to make a 110 outlet. Bad idea? View more questions Search
|