Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Toilet flange bolts make toilet sit at wrong angle
[ 2 Answers ]
Previous owners put a bathroom in the rec room. When they installed the toilet flange (to the sewer) it was not aligned with the wall. The toilet sits at a crooked angle, not aligned to the wall. After removing the toilet - the flange that holds the toilet bolt-downs needs to be rotated so...
Toilet Floor Flange Screws loose and will not tighten
[ 1 Answers ]
I had a leaking toilet wax seal. Pulled the toilet off cleaned all old wax. I noticed while cleaning wax off that two of the screws securing the floor flange to the subfloor (vinyl covering over a wood substrate) were loose and will not tighten up. I was told that perhaps the when they roughed it...
Water leak at floor near toilet mounting bolts
[ 2 Answers ]
We noticed occasional water seepage on floor near one of the mounting bolts. I assumed it was a faulty wax seal, so, we removed the toilet bowl, and replaced the seal. We thought the matter was resolved, but, then we observed that especially when there is weight on the toilet, water gushes from...
2" shower trap: won't tighten anymore, no leak, but still a tad loose.
[ 5 Answers ]
Hi there. I am currently installing a 2nd bathroom in our house. The shower trap moves a little, but I can't tighten it anymore, and water does not leak when I stick a hose down the drain. Can I cover this up even though it moves it a bit? Is it supposed to move at the swivel point even when...
Toilet leak at mounting bolts
[ 4 Answers ]
I have a mid-80's Crane toilet. I can not get it to stop leaking from the two mounting bolts. I've tried replacing the washers & bolts, cleaning the porcelein with scouring pad, and even using plumbers putty. Nothing works! I've tried tightening and loosening the bolts. I'm at my wits end and... View more questions Search
|