Ask Experts Questions for FREE Help !
Ask
    rebdab52's Avatar
    rebdab52 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 27, 2009, 01:55 PM
    Pilot light conversion
    Is there a kit to convert an lp furnace pilot light to electronic pilot ignition? It is in a 1998
    Manufactured home and is made by Nordyne. The wind blows the pilot out.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Oct 27, 2009, 02:00 PM
    Actually fix the wind problem is the solution. Mobile home furnaces are expensive to convert and most conversions are not UL/CSA or HUD listed so finding a kit will be about impossible.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Propane Furnace won't start no pilot light red light flashes 3 times [ 6 Answers ]

My propane furnace G6RC has no visible flame and the red light either stays on or flashes 3 times in a row and then the furnace shuts off and tries to restart

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

Intermittent pilot light burns well but main burners do not light [ 1 Answers ]

I have an Olson furnace with intermittent pilot light with electronic spark ignition. There is a Honeywell S8610U furnace controller. When thermostat calls for heat the ignitor sparks and the pilot flame lights. The flame continues to burn while the ignitor continues to spark for about 5+...

Pilot light stays on but pilot switch keeps resetting [ 5 Answers ]

I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...

View more questions Search