Ask Experts Questions for FREE Help !
Ask
    fatherbyrd's Avatar
    fatherbyrd Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 19, 2009, 07:29 AM
    Comfortmaker gaspack will not light
    When I turn up the stat the inducer blower comes on,the ignighter glows and I think I can here a click from the gas valve.but that is it.It is about 10 years old.It did this last year and I went out and tapped on the gas pipe a couple of times and had no more trouble all last winter.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Oct 19, 2009, 08:13 AM
    If the unit has a flame sensor clean it with steel wool or sandpaper. Or you can test it if you have the proper meter. This is the cheap fix if it works.
    Attached Images
     
    Attached Images
  1. File Type: pdf Doc1.pdf (42.4 KB, 120 views)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane gaspack [ 1 Answers ]

I have a trane gaspack and the heat will not work. The code on the LED states that I have a Flame Rollout switch open what can I do to fix it myself.

Troubleshooting Comfortmaker Heater blinking light [ 4 Answers ]

I have a comfortmaker central heater unit that won't stay on--there is a green blinking light on top of the gas regulator--what does it mean?

As to the bryant gaspack codes [ 1 Answers ]

The error code said processor detected error in software or hardware. It has a code for flame sensor.

Bryant Gaspack LED codes [ 1 Answers ]

I have a 588ANW048120 gaspac and the code led refers to the IGC error, I can reset the unit by cutting off main power and it comes on and works ofay for awhile then all of a sudden it does the same thing. Sometimes it will work OK for aday or two then again it may go and do it two times in one day....

Comfortmaker Heater won't light [ 1 Answers ]

Comfortmaker/Heil ~15yrs old (not sure) I had a failure of the forced draft motor... replaced it then the burner lit one time for about 15 seconds. I cleaned the flame sensor. Now the igniter comes on then goes off. I'm not certain but I can hear 2 clicks as the igniter goes off. What should I...

View more questions Search