Ask Experts Questions for FREE Help !
Ask
Page 3 of 3 « First < 3
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #41

    Apr 24, 2009, 07:33 PM

    Yep that is the one I think it is. Make sure the wires can not touch any metal.
    omgnowaykati's Avatar
    omgnowaykati Posts: 23, Reputation: 1
    New Member
    		  
    #42

    Apr 24, 2009, 07:36 PM
    Nothing, Doesn't turn on.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #43

    Apr 24, 2009, 07:39 PM

    Is it flashing a code again?
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #44

    Apr 24, 2009, 07:40 PM
    And you have the 2 wires pluged onto each other? 2 make a contenius loop?
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #45

    Apr 24, 2009, 07:43 PM

    Do you have AOL or aim? You can message me direct if you like it is faster.
    amaljeni's Avatar
    amaljeni Posts: 2, Reputation: 1
    New Member
    		  
    #46

    Nov 20, 2010, 12:03 PM
    Hi,
    How did u fix it, I have the same problem.

    Leo
    amaljeni's Avatar
    amaljeni Posts: 2, Reputation: 1
    New Member
    		  
    #47

    Nov 20, 2010, 12:39 PM
    Thanks guys,

    I turn-on the switch an press the reset button. Started working now. All this posting are very good.

    Thanks you very much,
Not your question? Ask your question View similar questions
 
Page 3 of 3 « First < 3

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Troubleshooting 4 flashing lights - open high temperature limit switch [ 7 Answers ]

Thanks for your input. I finally was able to reverse the wiring and got it squared away. While I was in the attic I thought I would replace the motor which drives the fly wheel. I thought I was a hero till I put everything together and discover 4 flashing lights. The lights indicate "open high...

Furnace won't light without a furnace switch reset [ 15 Answers ]

Hello I have a Tempstar/Keeprite furnace model HGF120NE-1, Serial number 8464124770. (the exterior of the furnace has Tempstar logo and interior of furnace has Keeprite logo.) This furnace has an intermittent pilot light system. At times, especially in the morning after allowing a...

Gas furnace still not blowing warm air after reset [ 2 Answers ]

We have the Carrier 9200 gas heat/cool unit (indoor). We followed the reset instructions and the fan is blowing but we're still getting cool air. What causes it to blow out only cool air and not warm? What else can we do. Again, our home is mainly gas and our oven works fine. I tested the Air...

Trane xe 80 open high temperature limit switch [ 1 Answers ]

Furnace is about 13 years old... we just replaced the ignighter in it last night because it was running through all the steps to run except ignighting. It fired right up and ran for about 7-8 hours... now it won't ignite at all (it is running through all the steps it needs to except for...

View more questions Search