Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Error code for "open pressure switch" on York natural gas furnace
[ 6 Answers ]
I get three red flashes from the furnace after an attempt sequence when the t-stat calls for heat. The motor starts, and seems to try to light but after about thirty seconds, it quits and gives the error code. I have removed both gray tubes from the pressure switch and made sure they are...
Blower Set to "Continuous Run" turns off Briefly when Compressor Cycles
[ 4 Answers ]
We have two AC units/zones servicing our house... We have both systems set (at the thermostat) to continuously run the blowers even if the compressor has cycled off. The blower on one unit, however, cycles off briefly for about 2 seconds when the air conditioner compressor turns off, despite...
Should I have the fan switch turned to "ON" or "AUTO"?
[ 6 Answers ]
Should I have the fan switch turned to "ON" or "AUTO"?
Convert a lamp to work on a "hot" switch via pull chain
[ 1 Answers ]
My builder wired a light in an arch way with a "hot" outlet. We put our pool table underneath the archway and now need to add a pool table lamp fixture. All the ones I can find require a light switch. Because the archway if solid wood there was no way to wire it to a switch so the builder told... View more questions Search
|