Ask Experts Questions for FREE Help !
Ask
    minpville's Avatar
    minpville Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 29, 2009, 07:48 PM
    Concord cg 90ca furnace will not stay lit
    My concord cg 90 ca furnace will not stay lit after calling for heat.th inducer motor turns on,the ignitor lights ang the gas flows,but after lighting the ignitor turns off and the burner shuts down.The green troubleshooting code flashes 6 times. No luck with cleaning the flame sensor either. Is the ignitor supposed to stay lit the entire time that the burner is on?
    smvtx2009's Avatar
    smvtx2009 Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Nov 3, 2010, 06:11 AM
    No. The ignitor is not supposed to stay on. Where is your fresh air inlet piped to? If it is not piped to an outside "fresh" air supply the furnace "sniffer" triggers and shuts the gas valve back off. If the fresh air inlet is piped to an outside source then the "sniffer" (sensor that the little tubes run to) may be bad. I have the same furnace and ran into the same problem, but at the time my fresh air inlet was not piped outside. Once I piped in fresh air it has worked since then.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Concord Gas Furnace [ 2 Answers ]

I have a Concord Gas Furnace Model CG90UB... it currently is wired to run the fan on low speed which I find is not adequate to move the air around the house... I would like to know how to change the fan speed to run on medium... the manual states there are four speeds... Low, Low Medium, Medium and...

Concord 90+ Furnace Not Stay Lit [ 3 Answers ]

I have a concord 90+ furnace that tries to heat. THe burners do light, but only for about 15 seconds and then they try the cycle over. It does this five times, then quits and the LED flashes 7 times. Any suggestions. I do not have the error code list.

Concord gas furnace [ 1 Answers ]

Hello Been looking at various problems with the concord. Most seem to be limit switches. Problem with mine is the small side hose from exhaust blower To switch is accumulating about inch of water in it And is shutting furnace down. Once tube is drained she fires up and Runs for 2 days then...

Concord 80 plus gas, furnace [ 5 Answers ]

Hi, glad to find some help, I found your site by accident,or my good fortune! I have a concord 80 , the thermostat clicks and the blower comes on but the furnace does not light,all help appreciated

Concord furnace? [ 1 Answers ]

I have a concord furnace model # rgu90a100d14-3a and was wondering what the cfm for this unit is?

View more questions Search