Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Which type of pipe is best?
[ 2 Answers ]
I'm remodeling a bathroom and the galvanized steel pipes are pretty rusty and just hard to work with. Would CPVC be a suitable replacement? It seems to be easy to work with. If not, what might be a better choice?
What type of pipe did I screw into?
[ 6 Answers ]
Hello, Not sure if I should be posting this in electrical vs plumbing. I was placing screws in the bathroom wall to secure a towel rack that my little daughter yanked off the wall :( I used an old stud detector and it indicated a stud was behind the drywall. I then screwed in a drywall...
Leaky Pipe Thread
[ 10 Answers ]
I am threading a male 3/4 in. copper connector into a female cast metal valve body. The first time I used 3 wraps of teflon tap and it leaked. The second time I used Master Pumber TFE past and it leaked after 10 minutes. I allowed the paste to dry for 1/2 hour before turning on the water supply....
Pipe type for drain
[ 1 Answers ]
An someone please explain the difference between dvw and water pipe as it pertaines to copper pipe fittings thanks tallgrass:o :o :confused: :o
How much pipe thread tape to use?
[ 5 Answers ]
Yikes. I was installing the tub spout and the copper stub-out was way too long. I measure and measured again and cut it too short. It doesn't extend far enough Into the spout to seal. Can I use silicone or something? What others options To I have? The spout is the type you described in a... View more questions Search
|