Ask Experts Questions for FREE Help !
Ask
    jchac's Avatar
    jchac Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 3, 2009, 08:00 PM
    trouble shooting
    hi
    I have 1997 dodge ram 1500 4x4 my tail light went out and then the single light would . Cheeked out both. Bulbs on the right side, know the kicker is the hazzards work, the turnsignal works, if I step on the break.pleas help. Note I have replaced the turnsignal switch.
    still no luck.
    bones252100's Avatar
    bones252100 Posts: 253, Reputation: 29
    Full Member
    		  
    #2

    Mar 3, 2009, 08:44 PM

    Did you replace the turn signal switch before or after this problem began? The bulbs & socket are obviously OK. You may have a wiring problem such as a broken ground wire.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trouble shooting furnace [ 3 Answers ]

Hello I have a Altra 90 SX Armstrong furnace that has a cycle problem. The model # is a GUK75D103A with a Heatcraft control board 404030001 Cat. # 70K98 The problem that I'm actually having is that it is going through its cycles OK, except the induced fan keeps running and won't shut off. ...

Trouble shooting the hot water boiler [ 5 Answers ]

We have hot water heating and when the boiler comes on after a few minutes when it is shutting down it makes a weird noise. Can you let me know why this is happening Thanks Jocey

Furnace Trouble shooting [ 1 Answers ]

I have an Coleman Evcon Furnace. Model #15020A the problem is I replaced the Inducer motor, and The furnace starts like normal but then the flames goes out after about a minute or two. The LED light says the Pressure switch is stuck open but it seems fine. I tried to replace the PC board but can't...

Trouble shooting GMP Furnace [ 1 Answers ]

I have a gmp075-4 gas fired furnace, I just replaced the gas valve and the thing starts up fine but when the burner fires and the hot bar goes out the burner goes out any ideas? Limit switch maybe ?

Trouble shooting a/c unit [ 2 Answers ]

How do I find out if a capaciter is bad or starter on a/c unit

View more questions Search