|
|
|
|
Junior Member
|
|
Feb 20, 2009, 03:44 PM
|
|
Originally Posted by this8384
I agree; A/C work sucks. They charge too much for the parts and the systems are ridiculous to work on sometimes. Good luck :)
To me it's worse than engine work
|
|
|
Junior Member
|
|
Feb 20, 2009, 03:47 PM
|
|
Oh, this is interesting - the receiver you speak about - hondapartsunlimited lists OEM part for $70 - $90
RockAuto has an AC Delco version for $12...
Am I missing something here!
|
|
|
Ultra Member
|
|
Feb 20, 2009, 03:49 PM
|
|
Nope, just smarter than a lot of people :)
Yes, they inject dye into the system, put some freon into it and let it circulate. The dye can be seen with an ultraviolet light; it glows neon green so you can pinpoint exactly where the leak is.
|
|
|
Junior Member
|
|
Feb 20, 2009, 03:52 PM
|
|
Originally Posted by this8384
Nope, just smarter than a lot of people :)
Yes, they inject dye into the system, put some freon into it and let it circulate. The dye can be seen with an ultraviolet light; it glows neon green so you can pinpoint exactly where the leak is.
Who's smarter? You? :)
Which of these is the orifice tube you speak of? I see the receiver/dryer (7), there is also a valve which has to be included with the receiver/dryer, but can also be purchased separately. Rock sells them discretely - so if only the receiver is needed and not the valve, there's a HUGE savings there.
http://www.hondapartsunlimited.com/s...itch=&hidIrno=
|
|
|
Ultra Member
|
|
Feb 20, 2009, 03:54 PM
|
|
It's a small piece, approximately 3-4" long. It's usually located in one of the lines.
|
|
|
Junior Member
|
|
Feb 20, 2009, 03:55 PM
|
|
Do you see it in the diagram - sorry, forgot to include the link initially
|
|
|
Ultra Member
|
|
Feb 20, 2009, 03:56 PM
|
|
No, I don't see it there. It may not even have one, to be honest.
Just make sure you replace the receiver drier if the system has been opened. It's cheap insurance.
|
|
|
Junior Member
|
|
Feb 20, 2009, 03:59 PM
|
|
Thanks. :)
That's it then? No need to replace the valve on top of the receiver or the "receiver pipe"?
That - and the shop fees for evacuating and cleaning and refilling the system - of course. :(
|
|
|
Ultra Member
|
|
Feb 20, 2009, 04:01 PM
|
|
That valve may come with it. In the diagram, it's #12, correct? The bracket for #7 shows that #12 comes with the whole part.
|
|
|
Junior Member
|
|
Feb 20, 2009, 04:03 PM
|
|
Yes, but if I buy from Rock Auto - or similar - the valve isn't included
It's a ~ $25 valve, if there's no need to buy it I won't!
|
|
|
Junior Member
|
|
Feb 20, 2009, 04:04 PM
|
|
Sorry, looks like I might be mixing parts.
Honda sells it and calls it a "switch".
Rock sells an "expansion valve".
IDK if they are the same thing or not.
|
|
|
Full Member
|
|
Feb 20, 2009, 04:05 PM
|
|
I would say that the compressor is shot if it is not making any noise. And if it needs to be replaced depending on the kind of system that you have than the accumulator or receiver dryer needs to be replaced as well. And if the system is low on refridgerant then there might be a leak somewhere but its most likely in the compressor because that's where most leaks are. So I would tell you that you would probably have to get a new compressor.
|
|
|
Junior Member
|
|
Feb 20, 2009, 04:07 PM
|
|
That's not very happy news...
It engaged once or twice today - it won't engage if it has low pressure.
Isn't it normal - or semi-normal - for a 6 1/2 yr. old R134 system to leak?
R134 has a very slippery molecular structure, much smaller than R12.
|
|
|
Ultra Member
|
|
Feb 20, 2009, 04:08 PM
|
|
#12 in the diagram is the air conditioning switch. That could also be the problem. If the switch is bad, it could be kicking off the A/C right after it kicks on.
The expansion valve is seperate; I don't think that's what #12 is.
And it's very normal for a 6-year-old system to leak :) O-rings shrink and crack, condensors get holes in them from road debris... anything is a possibility.
|
|
|
Junior Member
|
|
Feb 20, 2009, 04:14 PM
|
|
Worth noting that at least one other RSX owner reported that a dealer replaced his compressor when the leak was in fact caused by a bad O-ring.
Hence I think a leak test is probably a cost-effective choice...
|
|
|
Ultra Member
|
|
Feb 20, 2009, 04:15 PM
|
|
Yup indeedy... check for leaks. If nothing comes up, I'd try that switch.
|
|
|
Junior Member
|
|
Feb 20, 2009, 04:17 PM
|
|
Originally Posted by this8384
Yup indeedy...check for leaks. If nothing comes up, I'd try that switch.
Thanks again, 8384. :)
|
|
|
Full Member
|
|
Feb 20, 2009, 04:18 PM
|
|
It could also be a bad cycling clutch which can cause compressor failure and replacing a compressor clutch is a very common repair.
|
|
|
Full Member
|
|
Feb 20, 2009, 04:25 PM
|
|
All systems leak over a period but if they are in good condition they should only leak about half a pound per year and the most common place for leaks is at the compressor hose connections the best way to test for leaks is with an electronic leak detector. You also said it won't engage if it has low pressure so that can be bad high and low pressure cutoff switches
|
|
|
Junior Member
|
|
Feb 20, 2009, 04:25 PM
|
|
Originally Posted by Jlesnik33
It could also be a bad cycling clutch which can cause compressor failure and replacing a compressor clutch is a very common repair.
I've heard that too - but I was also told the clutch is electro-magnetic - how does it go bad? It's not like a transmission/engine clutch that wears down with use...
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
P0420 Code, 2002 Acura RSX
[ 102 Answers ]
I just got a CEL last night - P0420, catalyst system efficiency below threshold (bank 1).
VERY cold here, in the high single digits. Don't know if that's a factor or not.
Car has 80K miles on it, I replaced the OEM catalytic converter with a highflow cat a few months ago, no CEL was ever...
Pto stopped working
[ 2 Answers ]
Cub cadet electric clutch started and stopped I checked all the wireing it just stopped working today and will not start back up clutch or maybe something else thanks larry
Previously working electrical outlets stopped working
[ 2 Answers ]
Hi Everyone
A wall of electrical outlets in my kitchen just stopped working. They were working just fine about a month ago. I tried checking the circuit box, and turning the circuits on/off just to make sure anything that has been tripped was turned on back again. But it didn't work for the...
View more questions
Search
|