Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Armstrong ultra sx-80 furnace problems
[ 4 Answers ]
I have an armstrong ultra sx-80 gas furnace my problem is when I turn the unit on it will start up fine when I set it to heat, run for a few minutes then the flame dies. The blower stay on and will not shut off until I unplug the unit. The heat never reaches it's set point. If I wait for about 30...
Armstrong Ultra V
[ 1 Answers ]
Armstrong Air Ultra V, 4 yrs old: Problem: *Igniter comes on with bright red/blue flame *Burners then come on *Fan blower comes on *Shortly after blower comes on, burners go out, and blower continues to run *Igniter comes back on *Burners then come back on *Then Burners go out again...
Adding a Humidifier to a Armstrong Air Ultra V Tech 80
[ 1 Answers ]
I am installing an Aprilaire Humidifier 500a on an Armstrong Air Ultra V Tech 80 furnace. Where do I get the 24 VAC from the heating side of the furnace to feed the humidifier control?
Armstrong Ultra SX 80 Replacement Pressure Switch
[ 2 Answers ]
I need to replace my pressure switch made by TRIDELTA. I believe it is part number PPS10090-2615. It also has the following numbers: 046317/0014/B and 44819-002. Does anyone know what the specs are for this pressure swtich? Is there a less expensive option for replacement? Any feedback...
Armstrong Ultra sx 80, pilot light lit, but heater doesn't turn on
[ 4 Answers ]
We have a propane heater. We have propane in the tank. There is air blowing through the vents, but there is no heat. Usually, there is a clicking sound in the thermostat, a whumph sound in the heater and the heat comes on. Now there is no clicking sound and no whumph. Consequently, no heat. ... View more questions Search
|