Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Craftsman rider won't start
[ 8 Answers ]
Late '80's vintage 18HP, 44" rider. Been running like a champ until recently. Started running very rough a couple of weeks ago. Had to choke all the way to keep in running. Decided to start with new spark plugs to rectify. Now I don't get any spark. Turns over just fine. Amp meter on dash...
Murray 14 hp 42" cut Blade Drive Belt Loose
[ 3 Answers ]
What are ways of tightening the blade drive belt on a Murray Model 42813A Riding lawn mower with a 42" wide cut? Just installed new one & blades will turn while mower is stationary, but will stop while trying to run over any grass?
The Old "A" Drive
[ 4 Answers ]
Not being the brightest blip on the radar screen,I purchased a new computer that does not carry an A drive. Unfortunately I am old school and have many disks (originals) and no method of dealing with them. Is there anyway these disks may be copied to CDs and used accordingly? My biggest...
My 44" rider cuts to short for my liking
[ 5 Answers ]
I'm looking for advice. I raised the rear of my deck by moving the adjustments so now I want to put bigger deck leveling wheels to raise the front. It has three wheels lined up on the axle. Looks like clearance enough for wheels an inch larger. I can't stand cutting my lawn short and the highest...
AYP 18HP turns over slow
[ 5 Answers ]
I was given a mower that sat for 5 years. Put a new battery in, cleaned the spark plug but it seems to spin really slow and certainly not fast enough to start. Where do I start checking? I tried jumping it with my car after the battery got weak but got the same result... like the engine is bad. ... View more questions Search
|