Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Starting kawasaki kz650
[ 7 Answers ]
I just bought a 1977 kawasaki kz650. It ran fine when I got it home, and then I cleaned and sprayed some of the bike with a pressure washer. After that it started hard and now it doesn't start at all. I drained the gas and put new in, charged the battery, and cleaned the plugs. I don't why it won't...
Kz650 specs
[ 3 Answers ]
Can anyone tell me what the carb float measurement should be for a 1978 kz650. I just rebuilt the carbs and they still leak gas from the bowls. Any suggestions?
1977 KZ650 oil problem
[ 5 Answers ]
Just bought a 1977 KZ650 with 23,000 miles... there wasn't a drop of oil on the ground or on the bike (old or new) and the bike hadn't been moved in two plus weeks... I got the bike home (about a 30 minute ride) and found oil blowing out a small tube below the carbs... any ideas? What if anything...
Gasket Problems...
[ 2 Answers ]
I am changing out a shower and now I need to know which gasket goes first, (in the drain area).. the rubber or the friction? Appreciate the help I will get... George
Adhesive with gasket or not
[ 2 Answers ]
I am installing a PVC shower stall drain in a fiberglass shower unit. The drain unit has a rubber gasket and a friction gasket. Should I install the drain with or without a (latex adhesive) caulk applied to the gaskets? A picture of the drain unit is attached. (I hope) View more questions Search
|