Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Pumptrol Pressure Regulator adjustment
[ 12 Answers ]
How do I adjust the pressure regulator on a Pumptrol to increase the amount of pressure?
How to wire a 20-40# pumptrol pressure switch for a deep well?
[ 4 Answers ]
Hi all: My daughter asked me to wire power to her deep water well... I will be using #12 2 wire w/ ground through a 20 amp circuit breaker to a 20-40# pumptrol pressure control switch... The pumptrol has four terminals in a line, the two end terminals are marked "L" and the two center terminals are...
Adjusting psi on Square D Pumptrol switch
[ 1 Answers ]
My irrigation system requires the well pump psi to be set above 30 psi on the low end or else it drains the well. Once I cut the power and remove the cover to the Pumptrol switch, I turned down (clockwise) the center spring loaded screw down (the higher one upon which the cover was affixed). That...
How much well water pressure pumptrol broke
[ 1 Answers ]
Hello My name is Jim, I have a major problem. My pumtrol switch keep jumping off and don't turn back on unless I turn it on. Do I need to replace the switch? How much air pressure should be in the holding tank when dry and how much should be in the tank when filled with water? Can you tell me...
Square D Pumptrol Switch not "cutting in"
[ 6 Answers ]
I have a Square D Pumptol switch on the pump/pressure tank at my new house. I've never worked with any of this technology before; it's my first home purchase (yay!) and the only home I've ever lived in that didn't have city water. The pressure switch cuts off successfully at about 55 psi, but... View more questions Search
|