Ask Experts Questions for FREE Help !
Ask
    ran2857's Avatar
    ran2857 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 19, 2008, 05:50 PM
    Deere won't move
    My L t155 was due for some new cutting blades which I purchased from the dealer. I installed the blades myself since there wasn't a lot of mechanical involved. I also installed
    The belt that drives the cutting deck which also proved to be quite easy for me. Everything went very well and I buttoned everything up and hoped on the Deere ready to get mowing.
    Only problem was the mower would not move,either forward or backwards when I depress the pedals. This is a hydrostatic transmission and it was running the very best when I drove the tractor into the garage an hour earlier to start my repairs.

    I cannot figure this out. I did nothing that would have remotely been connected to the drive
    Train of the tractor. I know it is driven by a drive belt but it looks like it is turning fine. HELP!
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #2

    Aug 19, 2008, 06:55 PM
    On the back of the mower you should see a rod. It's called a tow valve rod. Make sure it is pushed all the way in.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

John Deere L110 Starts/ Will not move [ 4 Answers ]

My four year old John Deere had a flat tire. Jacked it up under the tranny housing fixed tire and put all back, now tractor starts fine, runs fine, but will not move forward of back. Has an automatic transmission, was running fine before tire change now doesn't move. It is not the brake and it is...

Deere L110 [ 1 Answers ]

How do you remove the carburetor bowl ? What is the purpose of the electrical connection attached to the carburetor ? I have water in the fuel system and want to clean the carburetor bowl. Can't see how it is attached.

John Deere L110 Starts Will Not Move [ 2 Answers ]

My L110 starts but will move neither forward or reverse. I've check the free-wheeling gear (OK) and the brake lock (OK). Still will not start. I was attempting to drive up a steep incline (about 20% grade) with a flat rear tire. After spinning for a while, I shut it down. Now after replacing the...

To move or not to move - Tub Drain [ 3 Answers ]

Hi there, I am installing a 72" soaker tub into a properly roughed in basement bathroom. The soaker tub's drain is not in the traditional spot and is positioned in the middle of the length of the bath. I have a 2" snub up located about 24-30" from where my tub drain will sit. Do I have to cut up...

View more questions Search