Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How to remove single valve handle - Delta Shower
[ 48 Answers ]
I've got the Seats & Springs to fix a leaky Delta Monitor 1400 Series faucet (and the water is turned off), and am stuck at the very beginning. The handle is a single lever, it appears that the Set Screw is missing. I've tried twisting the lever and pulling without success - not knowing which is...
DELTA shower trim replacement
[ 11 Answers ]
I have delta shower single lever controls from 1989 with the knob handle. They have the rectangular cam with the ball with 3 holes and 3 copper tubes to valve. The diverter is on the spout. What trim kits are available for this as I don't want to change the rough in valve? Do I change the...
Delta shower valve drip even after new ball and seats
[ 3 Answers ]
My delta shower single handle faucet has for quite sometime dripped when turned off--The valve is about 20 yrs old. I installed a new kit about 3 years ago due to a small drip (ball, seals and springs). Once the valve internals were replaced with a new ball, rubber seals and springs, and top...
Gas valve replacement
[ 1 Answers ]
I also have been having issues with my gas furnace. Apparently the needle valve inside is not working properly says the furnace repair man. He told me the valve needed to be replaced. Is this a part that can be easily removed and replaced by myself. I am a engineer if u care. What do I...
Bathtub removal and replacement
[ 2 Answers ]
I am about to embark on a rather ambitious 2nd floor bathroom refit at my son's house. The appliances are about 30 years old, and everything is going to be replaced; tub, sink/vanity,toilet, and tiles and gypsum board all around the tub. They have left too many tiles with missing grout for too... View more questions Search
|