Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replacing old thermostat with a Hunter 44110. Wiring issues.
[ 4 Answers ]
We had an older CArrier thermostat. The old wiring went as follows... Orange = o/w2 Red = R y/y2 Yellow G = Green C = Black (Common) W/W1 = White New thermostat has the following
Problems wiring Hunter 44110 thermostat
[ 1 Answers ]
I just bought a Hunter 44110 thermostat for an old gas wall heater. Only two wires came out of the wall and were unmarked (even the old thermostat didn't identify + and ground). I have read the instructions and connected one wire to ground and the other wire to RH. Note there is a jumper between...
Wiring a hunter 44110 5-2 programmable thermostat
[ 1 Answers ]
Am trying to install a new programmable thermostat and I am having problems. My old thermostat had the following wires: white, orange, red, green yellow and blue. The new Hunter thermostat has places for RH, RC, G, Y and W. I have tried several different configurations and cannot get the a/c to...
Hunter thermostat 44110
[ 2 Answers ]
I have hot water baseboard heat, and installed the hunter digital thermostat 44110, and followed the directions as directed, I had had wires W, Y and RH, I marked and installed Each of the wires, and put them where they were marked on the thermostat. I felt well and all of the lights ( temp,...
Hunter 44110 Programmable Thermostat Wiring HELP!
[ 3 Answers ]
My current thermostat has the following six wires, hooked as follows: Orange to O Green to G Yellow to Y1 Red to R Black to C White to W1 I am attempting to install the Hunter Programmable thermostat, which only gives me 5 placements for wires: View more questions Search
|