Ask Experts Questions for FREE Help !
Ask
    jfx's Avatar
    jfx Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Aug 5, 2008, 04:40 PM
    Wiring for a hunter 44110 thermostat
    My old therostat has two wires. I don't know where they hook up at in the hunter I bought the old wires are a red one and a white one I the old therostat is a robertshaw any help would be great
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #2

    Aug 5, 2008, 04:59 PM
    Are you using to control heat or cool? White is usually heat, blue or yellow MAY be for cool.
    jfx's Avatar
    jfx Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Aug 5, 2008, 05:32 PM
    The themostat controls both but I have to switch it over at the firance
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #4

    Aug 6, 2008, 06:16 AM
    A couple of extra conductors from thermostat to Unit will keep you from going to the furnace, all can be controlled at thermostat.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacing old thermostat with a Hunter 44110. Wiring issues. [ 4 Answers ]

We had an older CArrier thermostat. The old wiring went as follows... Orange = o/w2 Red = R y/y2 Yellow G = Green C = Black (Common) W/W1 = White New thermostat has the following

Problems wiring Hunter 44110 thermostat [ 1 Answers ]

I just bought a Hunter 44110 thermostat for an old gas wall heater. Only two wires came out of the wall and were unmarked (even the old thermostat didn't identify + and ground). I have read the instructions and connected one wire to ground and the other wire to RH. Note there is a jumper between...

Wiring a hunter 44110 5-2 programmable thermostat [ 1 Answers ]

Am trying to install a new programmable thermostat and I am having problems. My old thermostat had the following wires: white, orange, red, green yellow and blue. The new Hunter thermostat has places for RH, RC, G, Y and W. I have tried several different configurations and cannot get the a/c to...

Hunter thermostat 44110 [ 2 Answers ]

I have hot water baseboard heat, and installed the hunter digital thermostat 44110, and followed the directions as directed, I had had wires W, Y and RH, I marked and installed Each of the wires, and put them where they were marked on the thermostat. I felt well and all of the lights ( temp,...

Hunter 44110 Programmable Thermostat Wiring HELP! [ 3 Answers ]

My current thermostat has the following six wires, hooked as follows: Orange to O Green to G Yellow to Y1 Red to R Black to C White to W1 I am attempting to install the Hunter Programmable thermostat, which only gives me 5 placements for wires:

View more questions Search