Ask Experts Questions for FREE Help !
Ask
    fatboy123's Avatar
    fatboy123 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 14, 2008, 04:49 AM
    Craftsman 11hp 5 speed riding mower
    Ran well all last summer,but now it turns over but won't run,put gas in carb. And it run till that gas is used. This is an older riding mower and need some help.also is there a place on the net that I can find a manual and diagrams of motor
    Solarrigger2000's Avatar
    Solarrigger2000 Posts: 62, Reputation: 1
    Junior Member
    		  
    #2

    Jun 14, 2008, 06:50 AM
    Sounds like a clogged fuel line. Empty your tank and take off the lines. Attach them to an air compressor and try to blow out whatever it is.
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #3

    Jun 15, 2008, 07:55 AM
    Sounds like carb problems, remove the carb bowl and inspect the fuel for contaminants.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My murray 11hp riding lawn mower will not start. [ 1 Answers ]

I have tried all I know to try and still my murray 11hp mower won't run. I need to know if there are any more fuses besides the one by the celenoid. I replaced the battery, starter switch, celanoid, sparkplug, and 15amp fuse by the celenoid. Are there any more fuses that I should look for? ...

Diagram for replacing lawn mower belt on Sears Craftsman 4000 Riding Mower [ 9 Answers ]

I need a diagram on how to replace a belt on the Sears Craftsman II 4000 riding mower

My 11hp Craftsman riding mower will not start [ 2 Answers ]

My mower just keeps turning over but not starting up . I have checked everying ,all I know is I was cutting my land and it just died and now will not start . Please help thank you

Craftsman 11hp riding mower [ 5 Answers ]

I have a friend who has an old Craftsman 11hp riding mower and is having some problems. The ignition switch was broken and has been started with a screwdriver until it finally broke. I got a replacement switch today and installed it and now as soon as it is put in the "on" position the engine...

View more questions Search