Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Blower Motor wiring
[ 4 Answers ]
Blower motor has 4 wires +ground. 1 yellow 1 blk & 2 brwn(one with a small copper band on it) How is it to be wired to power? Which is common and which for speed? Thanks.
Bad Furnace Control Board?
[ 6 Answers ]
I have a Carrier 58PAV that intermittently aborts or sometimes clicks on and off at the draft blower stage. I found out I can move the control board (HK42FZ007) when the blower motor clicks off, and it clicks and comes right back on. If I hold it just right, the furnace starts and if I manage to...
Power to furnace control board but stops there
[ 3 Answers ]
Hi I was given a Nordyne KG6RA gas furnace. After installing, I turned on and there was a low hum when the power got to it. I held the door switch closed so I could see. After a few seconds there was a spark and then blue smoke and everything went dead. I could not see where the smoke came...
Wiring Remote Control Fan
[ 3 Answers ]
My son just bought a Hampton Bay ceiling fan that came with a remote control. He really didn't want the remote and wanted it wired with the switches on the wall. However the only way you can reverse the fan direction is with the remote so he wants to use the switches on the wall for the fan and...
Powering the G terminal on my furnace control board
[ 1 Answers ]
Hi! My furnace's control board recently blew and the repair guy replaced it with a different kind. Aparently the new board requires a wire from the thermostat to the G terminal to work the A/C fan, and the old one didn't. The repair guy would need to make another trip for this repair. I am... View more questions Search
|