Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bryant Furnace model 383KAV won't kick on
[ 10 Answers ]
I'm not getting any error led blips from the computer board. I can only see one limit switch which isn't tripped. I replaced the thermostat but that wasn't it. I've checked breakers and even tried tripping them off and then back on. Usually if I remember right this furnace goes through a...
Bryant gas furnace model 383 KAV sometimes does not run
[ 6 Answers ]
I have a 10 year old Bryant gas furnace model 383 KAV that sometimes does not run. The inducer motor does not come on and there are no codes. If I cycle the power several times it will eventually all work normally at least until the next morning when it may or may not restart after being off at...
Location of the flamer sensor in a Bryant Model 383K Furnace
[ 3 Answers ]
Where is the exact location of the flamer sensor in a Bryant Model 383K Furnace? Is there a better diagram than I currently have in my user's manual? It is really for the installer. I know that I need to sand down/ steel wool the flame sensor, but can't remember the location. Thanks in...
Bryant gas heater model beginning 310aav
[ 3 Answers ]
I had not used my furnace over the summer. Before turning on the thermostat, I replaced the filter and checked to make sure red light was on solid. Turned on thermostat and furnace light started blinking error code 23, which according to list on furnace means pressure switch obstructed or off. I... View more questions Search
|